Cleaning Process
 |
Pre-Treatment
First we apply a mild alkaline solution to a section of the floor and allow it to penetrate for up to 15 minutes.
This loosens the accumulated soil, grease, contaminates and topical residue. We do not use harsh acids
as these damage tile and grout. The alkaline solution does not produce any harmful fumes and ordinary
ventilation removes the mild scent within minutes of completion of the job.
Power Scrub Surface
Then special serrated bristles agitate the grout lines as well as the tile surface. Edge cleaning is also
done at this time.
Turbo Power Rinse
The tile and grout are rinsed using heated high pressure water. We not only clean the tile and grout but we
also sanitize both. The system generates water pressure of 1.000 to 1.200 P.S. while the water temperature
of approximately 240 degrees softens and extracts years of soil and contaminates. The floor tool connects
to a powerful vacuum hose which sucks the cleaning disk to the floor and confines the water spray inside
the disk. There is virtually no splash over to worry about. The vacuum hose draws away the water, along
with the dirt to a containment tank on our truck.
Speed Dry / Inspect
Removes all remaining water on floor. High powered air movers are put into place to dry tile and grout lines.
Then we inspect for any staining and spot clean any surfaces stains.
Impregnating Sealer
1-2 coats are applied, depending upon the porosity of the grout lines. This creates a barrier against future
staining, and will not change the color of your grout lines. Excessive sealer is buffed off tile and grout after
appropriate drying time
Servicing New Jersey and rest of the Tri-State area!
